Troy-Bilt ZT42 Benutzerhandbuch

Install the discharge chute deflector using the carriage 

3. 

bolts, push nuts and flange lock nuts as shown in Fig. 3-3 

and securely tighten the hardware.

To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan 

attached.

Cut any straps securing the seat assembly and the drive 

1. 

control levers to the tractor. Remove any packing material.

NOTE: Be careful not to cut the wiring harness connecting the 

seat and the seat switch.

Remove the two shoulder bolts and lock nuts in the seat 

2. 

pan as shown in Fig. 3-4.

 

Rotate the seat into position and secure the seat into place 

3. 

with the previously removed shoulder bolts and lock nuts. 

Be careful not to crimp or damage the wire harness while 

installing the seat. See Fig. 3-5.

The drive control levers of the tractor are lowered for shipping 

purposes. The flange lock nuts, hex screws, and flat washers that 

normally secure the control levers in their operating position 

are unfastened and installed in the slotted holes of the control 

levers for shipment. The control levers must be repositioned to 

operate the tractor. To reposition the control levers for operation, 

proceed as follows:

Remove the hex screw, flat washer, and flange lock nut 

1. 

from the slot of one of the drive control levers.
Lift and swing that control lever upward until the slotted 

2. 

hole in the lever bracket aligns with one of the holes in the 

pivot bracket. See Fig. 3-6.