Troy-Bilt 2840 Benutzerhandbuch

At least once a season, remove the shear pins from the auger 

shaft. Spray lubricant inside the shaft and around the spacers 

and the flange bearings found at either end of the shaft. 

See Fig. 6-3.

If the full range of speeds (forward and reverse) cannot be 

achieved, refer to the figures to the right and adjust the shift 

cable as follows:

Place the shift lever in the fastest forward speed position.

1. 

Loosen the hex  nut on the shift cable index bracket. See 

2. 

Fig. 6-4.

Pivot the bracket downward to take up slack in the cable. 

3. 

Retighten the hex nut.

4. 

Refer to the Assembly and Set-up section for instructions on 

adjusting the auger control cable.

Refer to the Assembly and Set-up section for instructions on 

adjusting the skid shoes chute assembly.

Refer to the Assembly and Set-up section for instructions on 

adjusting the skid shoes.