Troy-Bilt 3310XP Benutzerhandbuch

Two replacement auger shear pins are included 

with this manual (or stowed in the plastic handle panel). Refer to 
the Maintenance section for more information regarding shear 
pin replacement.
NOTE: All references in this manual to the left or right side of the 
snow thrower is from the operating position only. Exceptions, if 
any, will be specified.

This unit is shipped with the engine full of oil. 

After assembly, refer to the separate Engine Owner’s Manual 
included with this unit for fuel and oil fill-up details.
NOTE: Specifications are subject to change without notification 
or obligation. Images may not reflect your exact model and are 
for reference purposes only.

1. 

Remove any packaging material from the upper handle. 

2. 

Remove the lower plastic wing nut, belleville washer and 
carriage bolt from each side of the upper handle; then raise 
the upper handle assembly until it snaps over the lower 
handle. See Figure 3-1.

3. 

Looking beneath the handle panel, check that all of the 
cables (steering, auger, shift, and drive) are properly routed 
and not pinched or kinked. Make certain the springs at the 
lower end of the auger and drive cables are securely hooked 
into their respective actuator bracket.  See Figure 3-10.

4. 

Secure the upper handle and lower handle with the two 
wing nuts, belleville washers, and carriage bolts removed 
earlier. Tighten the two wing nuts already installed in the 
upper holes to firmly secure the upper handle and support 
tubes. See Figure 3-2.

1. 

Loosen, but do not remove, the chute crank bracket in 
order to attached the chute assembly.  See Figure 3-3.

• 

One Snow Thrower

• 

Two Replacement Auger Shear Pins

• 

One Chute Assembly

• 

One Snow Thrower Operator’s 
Manual

• 

One Engine Operator’s Manual

• 

One Product Registration Card