Troy-Bilt Squall2100 Benutzerhandbuch

2. 

Align the holes in the chute base with the holes in the 

lower chute and secure with the previously removed hex 

washer screws. See Fig. 3-4.

To install the chute rotation control (only models so equipped) 

proceed as follows:
1. 

Remove the hex lock nut and machine screw from the 

chute rotation control. See Fig. 3-5.

2. 

Place the chute rotation control onto the chute rotation 

rod and secure with the hex lock nut and machine screw 

removed in step 1. See Fig. 3-5.

1. 

Remove the carriage bolts and flange lock nuts from the 

drift cutters.

2. 

Install the drift cutters and secure with the carriage bolts 

and flange lock nuts removed in step 1. See Fig. 3-6.

1. 

Remove the eye bolt and handle knob from the manual 

bag.

2. 

Place the eye bolt and handle knob on the upper handle 

as shown in Fig. 3-7. Do not fully tighten the hardware until 

instructed to do so.

NOTE: The opening of the eye bolt should face toward the 

back of the snow thrower.