Troy-Bilt Flurry 1400 Benutzerhandbuch

NOTE: Do not plug your extension cord into the power source 

receptacle (outlet) prior to routing it through the cord retainer 

and connecting the extension cord to the snow thrower’s power 

cable.
To properly route your extension cord through the strain reliever:
1. 

Approximately 14 to 16 inches from its end, crease your 

extension cord to form a tight loop.

2. 

Push the loop through the bottom hole in the strain 

reliever.

3. 

Position the loop over the clips found on the strain reliever 

and pull down until the cord fits snugly into the clip. See 

Fig. 3-10.

NOTE: Use a UL-approved extension cord. A 100-foot, 

14-gauge cord is recommended. A 50-foot, 16-gauge 

cord is acceptable. Refer to the small chart found in Safe 

Operation Practices.
NOTE: The strain reliever reduces strain on the extension 

cord so that it does not come unplugged during operation.

4. 

Plug the snow thrower power cable into the extension 

cord. See Fig. 3-10.

5. 

Install the chute in the auger housing with the handle 

facing towards the rear of the snow thrower. See Fig. 3-8.

6. 

Re-install the front cover with the four screws removed in 

step 1. See Fig. 3-9.