Troy-Bilt Storm 2410 Benutzerhandbuch

Carefully remove the hex nut which secures the hex shaft to 

5. 

the snow thrower frame and lightly tap the shaft’s end to 

dislodge the ball bearing from the right side of the frame. 

See Fig. 8-9.
NOTE: Be careful not to damage the threads on the shaft.

Carefully position the hex shaft downward and to the left 

6. 

before carefully sliding the friction wheel assembly off the 

shaft. See Fig. 8-10.
NOTE: If you’re replacing the friction wheel assembly as a 

whole, discard the worn part and slide the new part onto 

the hex shaft. 

Follow the previous steps in reverse order to reassemble 

components. If you’re disassembling the friction wheel and 

replacing only the rubber ring, proceed as follows:

Remove the four screws which secure the friction wheel’s 

1. 

side plates together. See Fig. 7811

Remove the rubber ring from between the plates.

2. 

Reassemble the side plates with a new rubber ring.

3. 

NOTE: When reassembling the friction wheel assembly, 

make sure that the rubber ring is centered and seated 

properly between the side plates. Tighten each screw 

only one rotation before turning the wheel clockwise 

and proceeding with the next screw. Repeat this process 

several times to ensure the plates are secured with equal 

force (between 6 ft-lbs and 9 ft-lbs).
Slide the friction wheel assembly back onto the hex shaft 

4. 

and follow the steps above in reverse order to reassemble 

components.