Troy-Bilt Super Bronco Benutzerhandbuch

2. 

Using two hex screws and two flange lock nuts, loosely 

attach the handlebar support using the upper holes. 

Tighten the two screws securely. See Fig. 3-2.

3. 

Loosely attach the support brackets to the outside of the 

handlebar assembly using the carriage bolt, bell washer 

and knob. Refer to Fig. 3-3.

NOTE: If a support bracket will not move, loosen the 

attaching hex screws (5⁄16-18 x .75) and flange lock nuts (5⁄16-

18) at the base of the support brackets.
NOTE: The support brackets must be assembled to the 

outside of the handlebar assembly.

4. 

There are three height adjustment holes in the handlebar 

support bracket. Use a setting that will position the 

handlebars at approximately waist level when the tines are 

3-4” into the soil. To adjust the height of the handlebars 

loosen the knob on the handle, pull out on the carriage 

screw, adjust to the desired setting, push the carriage 

screw in until the square portion of the screw locks into 

place and re-tighten the knob. See Fig. 3-4.

4. 

Tighten all the handlebar mounting hardware securely.

To roll the tiller off the shipping platform, put the wheels in 

freewheel, as follows: 
1. 

Place a sturdy block under the transmission to raise one 

wheel about 1” off the ground.

2. 

Remove the wheel drive pin from the wheel hub and wheel 

shaft. See Fig. 3-5.