Turbosound TA-500tDP Benutzerhandbuch

 

The DSP parameters are organised by channel. The currently selected channel is shown in 
the top left hand corner of the display. You can navigate between the channels by pressing 
the channel buttons. Pressing the channel buttons will scroll through the channels, utilities 
and back to the default screen. When using a Preset that is stereo linked, the channel 
selection will reflect this. For example ‘1&4’ indicates outputs 1 and 4. When navigating onto 
an output channel, the usage of the output, as define in the factory preset, will be shown 

briefly at the top of the screen. 

 

LMS-D26

a

b

c

CHANNEL

EDIT

 

Pressing the edit navigation buttons gives access to the various pages of parameters 
available for each channel. The currently selected page is shown in the bottom left hand 
corner of the display, this is omitted on some pages where the function is obvious. The 
screen shows up to three (normally related) parameters for a given part of the processing 

functions on a given channel. 

The edit buttons allow you to scroll, in either direction, through the different processing 
pages for a given Channel. When you go past the last page, you will be returned to the 

default page. 

The channel buttons allow you to scroll, in either direction, through the input and output 

channels, whilst trying to maintain the currently viewed processing block. If the channel you 
scroll to does not have the currently viewed processing block, the next one will be shown 
instead. 

NB. When the unit powers-up, the settings will be the same as those when the unit was last 
switched off.