GE ZBD7000 Benutzerhandbuch
Installation Instructions
11
STEP 5 INSTALL POWER CORD
SKIP THIS STEP IF DISHWASHER
WILL BE DIRECT WIRED
WILL BE DIRECT WIRED
• Maximum power cord length is 6 ft.
• The power cord and connections must comply with
• The power cord and connections must comply with
the National Electrical Code, Section 422 and/or
local codes and ordinances.
local codes and ordinances.
Insert power cord wires
through strain relief and
tighten.
through strain relief and
tighten.
STEP 6 LEVEL DISHWASHER
• Carefully, upright the dishwasher, be careful not to
bend the leveling legs.
• Check to be sure the dishwasher is level and is
adjusted to fit the installation cutout height.
• Strip 1/2" insulation
from ends of power
cord wires.
cord wires.
• Connect incoming power cord white to dishwasher
white, black to black and ground to dishwasher green
wire. Use UL listed wire connectors of appropriate size.
wire. Use UL listed wire connectors of appropriate size.
• Install junction box cover with screws provided. Be sure
wires are not pinched under the cover.
Level
Top
and
and
Sides
White
Ground
Black
STEP 7 SLIDE DISHWASHER
INTO OPENING
DO NOT PUSH AGAINST THE FRONT PANEL WITH
KNEES, DAMAGE WILL OCCUR!
• Insert drain hose into the cabinet wall hole. If a power
KNEES, DAMAGE WILL OCCUR!
• Insert drain hose into the cabinet wall hole. If a power
cord is used, guide the end through a separate hole.
STEP 8 CONNECT WATER LINE
NOTE:
If you are using an existing water line, cut 1" off
the end. Always use a new ferrule and compression nut.
• The water supply line should be flushed to clear any
• The water supply line should be flushed to clear any
foreign material before connecting to the dishwasher.
• Make sure there are no sharp bends or kinks to restrict
water flow.
• Insert water line into the 90
°
elbow.
• Slide ferrule against
elbow and secure with
compression nut.
compression nut.
• Replace access panel
plate.
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher.
of dishwasher.
• Slide dishwasher into the opening a few inches at a
time. As you proceed, pull the drain hose through the
cabinet wall under the sink.
cabinet wall under the sink.
• Check to be sure there is no interference with
waterline or house wiring.
• Again, check to be sure the dishwasher is level.
Ferrule
90
°
Elbow
Hot Water
Supply Line
Compression Nut