JVC HR-V205EK Benutzerhandbuch

plug&play setup

Check that the

connection is completed

Tune the TV to your

Video Channel or to its

AV mode

Load the batteries into

the Remote Control

Refer to the Remote

Control diagram on

pages 6–7

Unless indicated

otherwise, use the

buttons on the Remote

Control

Start Plug&Play Setup

Plug the mains power cord into a mains outlet.

  Turn on the VCR.

  The Plug&Play screen

appears on the TV screen. Then press OK.

If you have connected your TV to the VCR with
only the RF cable and the on-screen display
appearing on UHF channel 52 looks distorted,
perform “

Video Channel Set

”

 

on page 14.

The VCR is automatically setting up the tuner
channels. This only happens the first time that you
plug the main power cord into the main outlet.

When Plug&Play is completed, the Confirmation
screen appears.

The TV should be set to its AV mode (if you are using both the RF cable and 21-pin SCART cable for
connection) or UHF channel 52 (if you are using only RF cable for connection).

  HR-V205EK-EN/p08-12

6/19/03, 1:34 PM

10