Konica Minolta bizhub C652DS Benutzerhandbuch
bizhub C652/C652DS/C552/C552DS/C452
8-7
8.1
Paper
8
Loading paper into the LCT
The same procedures can be used to load paper into the Large capacity unit LU-301 and LU-204.
The following procedure describes how to load paper into Large capacity unit LU-301.
0
To change the paper size, contact your service representative.
1
Open the upper door.
NOTICE
Be careful not to touch the surface of the paper take-up roller with
your hand.
your hand.
2
Lift up the paper take-up roller, and then load the paper into the
tray.
tray.
% Load the paper into the tray so that the side of the paper to be
printed on (the side facing up when the package was
unwrapped) faces down.
unwrapped) faces down.
% Do not load so many sheets of paper that the top of the stack
is higher than the mark.
% Do not load the LCT with paper of a size other than that
previously specified.
% If paper is curled, flatten it before loading it.
% If special paper is loaded, the paper type must be specified.
% Load letterhead paper so that the side to be printed on faces
up.
d
Reference
To configure paper settings:
Press [Basic] ö [Paper].