Konica Minolta bizhub C652DS Benutzerhandbuch

bizhub C652/C652DS/C552/C552DS/C452

4-12

This section describes the procedures for configuring settings for the control panel and adjusting the touch 
panel.

0

To return to the basic settings screen from the Accessibility Setting screen, press the [Accessibility] key, 
the [Reset] key or [Close].

0

In the Enlarge Display screen, [Default Enlarge Display Settings] appears, enabling you to configure 
default settings for use in the Enlarge Display mode using the copy or fax/scan functions.

%

Press the [Accessibility] key.

Page 1/2

Page 2/2

Touch Panel Adjustment

Adjust the position of touch panel buttons when they do not respond cor-
rectly because they may not be correctly aligned with the position of the 
actual touch sensor.
•

The touch sensors are not aligned in the touch panel if pressing [Touch 
Panel Adjustment] does not activate any action. Press the [1] key on the 
keypad.

•

Press the four check point buttons ([+]) on the touch panel adjustment 
screen while listening on a buzzer sound each time. When the checking 
by pressing the check point buttons is completed successfully, the in-
dicator on the [Start] key lights up in blue. Press the [Start] key.

•

The check point buttons ([+]) can be pressed in any order.

•

To perform adjustment again, press the [C] (Clear) key, and then press 
the four check point buttons ([+]) again.

•

To cancel the touch panel adjustment process, press the [Stop] or [Re-
set] key.

•

If the touch panel cannot be adjusted, contact your service represent-
ative.