Sharp DX-B450P Benutzerhandbuch

     Binary PS

On/Off

On

When On, the feature allows all binary codes 
to be processed by the PostScript interpreter. 
When Off, special binary control codes may 
be intercepted per the Format item setting.

     Factory Defaults

Yes
No

No

Resets the menu to factory network defaults. 

     Connection Speed 

Auto-Sense 
100Mbit Half
100Mbit Full
10Mbit Half
10Mbit Full

Auto-Sense

Configures the Ethernet connection speed 
(10 or 100 Mbits/second) and 
communication mode (full or half duplex). 
The “Auto Sense” setting attempts to 
auto-negotiate this connection with the 
networking hardware, usually a switch. 
When a setting other than “Auto Sense” 
must be used, the following should be 
considered: If connected to network switch, 
the “100Mbit/Full” setting can be used. If 
connected to a hub, use the “100Mbit/Half” 
setting. 

     Bidirectional

On/Off

On

When this setting is “on”, the printer may 
receive and send information over the 
network interface. When this setting is “off”, 
the printer will only receive information 
over the network interface. This applies 
primarily when using printing over a “Port 
9100” connection. This setting normally 
should be left at its default setting, should 
only be turned “off” under special 
circumstances

.

     Wait timeout

0000-9999

0270

(In Seconds): Specifies the amount of time 
the printer will allow a network connection 
to remain open without transferring data 
before the printer terminates the connection.

     SNMP On/Off

On/Off

On

     HTTP Port

00000-99999

00080

Specifies the TCP port number to use for 
HTTP connection to the printers embedded 
web server.

     IP Filtering

Disabled
Enabled

Disabled

(available via web server only): Allows an 
administrator to control access to printing 
and access to the embedded web server on 
the basis of IP addresses. This is a security 
feature.

This item allows you to set up the USB 
interface.

     Interpreter

Auto Switch
PCL
PostScript 3

Auto Switch