Panasonic PT-DZ680ULS Benutzerhandbuch
ENGLISH - 41
Chapter 3 Basic Operation — Switching on/off the projector
or higher, turn off the main power, and then turn on the power again.
r
f
If the [PROJECTOR SETUP] menu → [STANDBY MODE] (x page 76) is set to [ECO], there may be a time lag of approximately 10
seconds between turning on the power and starting projection compared to when the setting is [NORMAL].
r
f
If the <MAIN POWER> switch was turned <OFF> during projection the last time that the direct power off function was used, and the <MAIN
POWER> switch is turned <ON> while the main power plug connected to the outlet, the power indicator <ON (G)/STANDBY (R)> will light in
green and the image will soon be projected on the screen.
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
4)
3)
6)
2)
2)
1)
6)
3)
5)
7) 9)
1) 8)
5) 7) 8) 9)
1)
Press the <FOCUS> button to roughly adjust
the focus of the image. (x page 43)
2)
Set the projection method using [PROJECTION
METHOD] (x page 73) and [COOLING
CONDITION] (x page 74) on the menu.
r
f
Refer to “Navigating through the menu” (x page 49) for the
operation of the menu.
3)
Press the input selection (<RGB1>,
<RGB2>, <DVI-D>, <VIDEO>, <S-VIDEO>,
<HDMI>) buttons to select the input signal.
(x page 46)
4)
Adjust the front, back and sideway tilt
of the projector with the adjustable feet.
(x page 32)
5)
Press the <SHIFT> button to adjust the
position of the image. (x page 43)
6)
If the input signal is an RGB input signal, press
the <AUTO SETUP> button. (x page 46)
7)
Press the <ZOOM> button to adjust the size of
the image to match the screen. (x page 43)
8)
Press the <FOCUS> button again to adjust the
focus.
9)
Press the <ZOOM> button again to adjust the
zoom and the size of the image to match the
screen.
Switching off the projector
1)
1)
3)
2)
2)
4)
1)
Press the power standby <v> button.
r
f
The
[POWER OFF(STANDBY)] confirmation screen is
displayed.
2)
Use qw to select [OK], and press the <ENTER>
button.
(Or press the power standby <v> button
(Or press the power standby <v> button
again.)
r
f
Projection of the image will stop, and the power indicator <ON
(G)/STANDBY (R)> on the projector lights in orange. (The fan
keeps running.)