ZyXEL 202H 91-003-194003B Benutzerhandbuch
Produktcode
91-003-194003B
P-202H Plus v2 User’s Guide
167
Chapter 16 Menu 1 General Setup
2 Fill in the required fields. Refer to the table shown next for more information about these
fields.
16.2.1 Procedure to Configure Dynamic DNS
Note: If you have a private WAN IP address, then you cannot use Dynamic DNS.
To configure Dynamic DNS, go to Menu 1 - General Setup and select Yes in the Edit
Dynamic DNS field. Press [ENTER] to display Menu 1.1 - Configure Dynamic DNS as
shown next.
Dynamic DNS field. Press [ENTER] to display Menu 1.1 - Configure Dynamic DNS as
shown next.
Figure 76 Menu 1.1 Configure Dynamic DNS
Table 55 Menu 1 General Setup
FIELD
DESCRIPTION
System Name
Choose a descriptive name for identification purposes. It is recommended you
enter your computer’s “Computer name” in this field. This name can be up to 30
alphanumeric characters long. Spaces are not allowed, but dashes “-” and
underscores "_" are accepted.
Location
Enter the geographic location (up to 31 characters) of your ZyXEL Device.
Contact Person's
Name
Enter the name (up to 30 characters) of the person in charge of this ZyXEL
Device.
Domain Name
Enter the domain name (if you know it) here. If you leave this field blank, the ISP
may assign a domain name via DHCP. You can go to menu 24.8 and type "sys
domainname" to see the current domain name used by your router.
The domain name entered by you is given priority over the ISP assigned domain
The domain name entered by you is given priority over the ISP assigned domain
name. If you want to clear this field just press [SPACE BAR] and then [ENTER].
Edit Dynamic DNS Press [SPACE BAR] and then [ENTER] to select Yes or No (default). Select Yes
to configure Menu 1.1: Configure Dynamic DNS discussed next.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.
Menu 1.1 - Configure Dynamic DNS
Service Provider= WWW.DynDNS.ORG
Active= No
Host=
EMAIL=
USER=
Password= ********
Enable Wildcard= No
Active= No
Host=
EMAIL=
USER=
Password= ********
Enable Wildcard= No
Press ENTER to Confirm or ESC to Cancel: