IBM Flex System V7000 Expansion Enclosure 4939H29 Benutzerhandbuch
Produktcode
4939H29
8068ch06-Volumes.fm
Draft Document for Review January 29, 2013 12:52 pm
242
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
6.1 Storage provisioning from IBM Flex System V7000 Storage
Node
Node
This section follows the setup process and shows how to create volumes and make them
accessible from the host. The following steps are required to complete the basic setup of your
environment:
accessible from the host. The following steps are required to complete the basic setup of your
environment:
1. Create new volumes - starting at 6.1.1, “Creating a generic volume” on page 244
2. Create New Host - 6.2, “Creating a new host” on page 256
3. Map volumes to the host 6.3, “Mapping a volume to the host” on page 261
Discovery of the volumes from the host and multipath settings are discovered in Chapter 12,
“Host Configuration” on page 473.
“Host Configuration” on page 473.
Open the All Volumes window of the IBM Flex System V7000 Storage Node GUI (Figure 6-1)
to start the process of creating new volumes.
to start the process of creating new volumes.
Figure 6-1 Home window