ZyXEL Prestige 202H Plus ISDN Router 91-003-154001B Benutzerhandbuch

P-202H Plus v2 User’s Guide

Chapter 20 Remote Node Configuration

194

1 To configure the TCP/IP parameters of a remote node, first configure the three fields in 

Menu 11.1 - Remote Node Profile, as shown in the following table. 

2 Move the cursor to the Edit IP field in Menu 11 - Remote Node Profile, and then press 

[SPACE BAR] to toggle and set the value to Yes. Press [ENTER] to open Menu 11.3 - 
Remote Node Network Layer Options.

Figure 92   Menu 11.3 Remote Node Network Layer Options

The following table describes the fields in this menu.

Table 67   TCP/IP-related Fields in Remote Node Profile

Rem IP Addr

Enter the IP address of the remote gateway in Menu 11.1 - Remote Node Profile. 

You must fill in either the remote ZyXEL Device WAN IP address or the remote 

ZyXEL Device LAN IP address. This depends on the remote router’s WAN IP i.e., 

for the (remote) ZyXEL Device, the My WAN IP Addr settings in Menu 4. For 

example, if the remote WAN IP is set to 172.16.0.2 (the remote router’s WAN IP), 

then you should enter 172.16.0.2 in the Rem IP Add field. If the remote WAN IP is 

0.0.0.0, then enter 192.168.1.1(the remote router’s LAN IP) in the Rem IP Addr 

field).

Edit IP

Press [SPACE BAR] and then [ENTER] to select Yes and press [ENTER] to go to 

Menu 11.3 - Remote Node Network Layer Options.

 Menu 11.3 - Remote Node Network Layer Options

   Rem IP Addr: 0.0.0.0 (r.o.)
   Rem Subnet Mask= 0.0.0.0
   My WAN Addr= 0.0.0.0

   NAT= SUA Only
     Address Mapping Set= N/A

   Metric= 2
   Private= No
   RIP Direction= Both
     Version= RIP-2B

   Press ENTER to Confirm or ESC to Cancel:

Table 68   Menu 11.3 Remote Node Network Layer Options

Rem IP Addr

This will show the IP address you entered for this remote node in the previous 

menu.

Rem Subnet Mask Enter the subnet mask for the remote network.