ZyXEL Prestige 202H Plus ISDN Router 91-003-154001B Benutzerhandbuch

P-202H Plus v2 User’s Guide

199

Chapter 21 Static Route Setup

Figure 95   Menu 12 IP Static Route Setup 

Now, type the route number of a static route you want to configure.

Figure 96   Menu12.1 Edit IP Static Route

The following table describes the fields for Menu 12.1 – Edit IP Static Route Setup.

 Menu 12 - IP Static Route Setup

        1. ________
        2. ________
        3. ________
        4. ________
        5. ________
        6. ________
        7. ________
        8. ________

Enter selection number:

Menu 12.1 - Edit IP Static Route

         Route #: 2
         Route Name= ?
         Active= No
         Destination IP Address= ?
         IP Subnet Mask= ?
         Gateway IP Address= ?
         Metric= 2
         Private= No

Press ENTER to Confirm or ESC to Cancel:

Table 69   Menu12.1 Edit IP Static Route

Route #

This is the index number of the static route that you chose in menu 12.

Route Name

Type a descriptive name for this route. This is for identification purpose only.

Active

This field allows you to activate/deactivate this static route.

Destination IP Address

This parameter specifies the IP network address of the final destination. 

Routing is always based on network number. If you need to specify a route to 

a single host, use a subnet mask of 255.255.255.255 in the subnet mask field 

to force the network number to be identical to the host ID.

IP Subnet Mask

Type the subnet mask for this destination. Follow the discussion on IP 

Subnet Mask in this manual.

Gateway IP Address

Type the IP address of the gateway. The gateway is an immediate neighbor 

of your ZyXEL Device that will forward the packet to the destination. On the 

LAN, the gateway must be a router on the same segment as your ZyXEL 

Device; over WAN, the gateway must be the IP address of one of the remote 

nodes.