Addonics CipherChain Kit CCM35MK1 Benutzerhandbuch

Produktcode
CCM35MK1
Seite von 5
www.addonics.com
Addonics Technologies Inc.
1918 Junction Avenue, San Jose, CA 95131
Phone: 408.573.8580 | Fax: 408.573.8588
    
INTRODUCTION
 
 
Have you been looking for a simple and affordable solution to add 
bulletproof security to your system or your data storage equipment? The 
Addonics family of CipherChain products is the answer. Designed using 
the same field proven in both the Addonics Diamond Cipher and Ruby 
Cipher AES 256-bit crypto engine (NIST and CSE certified), the 
Addonics CipherChain is a small encryption module, the size of a 
compact flash, that can be easily installed into any computing 
equipment. Practically any desktop PC, server, rack mounted system, 
kiosk or external storage system can be secured with CipherChain 
products.
 
The standard CipherChain comes with one internal SATA host port and one internal SATA device port to encrypt 
any internal SATA storage device. The CipherChain-e, a model that comes equipped with one internal SATA 
host port and one eSATA port to secure the data stored in any eSATA storage devices. Both CipherChain uses 
the same AES 256-bit encryption.
Model: CCM35MK1, CCM35MK2
CipherChain Kit for 3.5" drive bay
Simple to use
Similar to all other Addonics encryption products, the CipherChain are pure hardware solution, meaning there is 
no software to run, no driver to install, and no password to remember. There is very little user training required to 
use the CipherChain products. All the user needs to do is to the correct Cipher key before powering on the 
system or the storage device. The family of CipherChain products can be operated under any operating system 
and this makes the CipherChain and the CipherChain-e an ideal security solution for organizations with heteroge-
neous computing environments and legacy systems.
Easy to install 
The CipherChain family of products is a simple pass through device that works with any SATA I/II/III hard drive, 
SSD (Solid State Drive), or storage device with SATA interface. The SATA hard drive to be encrypted is first 
connected to the device side of the CipherChain and the host side (blue SATA connector) of the CipherChain, in 
turn, connects to the SATA port on the system board or a SATA controller. For the CipherChain-e, the device side 
is equipped with an eSATA port to encrypt any eSATA storage device.