LevelOne 24 FE PoE + 2 GE Combo SFP L2 Managed Switch, 380W FGP-2472-v1 Benutzerhandbuch
Produktcode
FGP-2472-v1
www.level1.com
I
one world_one brand_one level_
Ethernet Switches
Technical Specifications
Standard Compliance
IEEE 802.3 10Base-T Ethernet (Twisted-pair Copper)
IEEE 802.3u 100Base-TX Ethernet (Twisted-pair Copper)
IEEE 802.3ab 1000Base-TX Ethernet (Twisted-pair Copper)
IEEE 802.3z 1000Base-X Ethernet
IEEE 802.3x Flow Control Capability
ANSI/IEEE 802.3 Auto-negotiation
IEEE 802.1q VLAN
IEEE 802.1p Class of Service
IEEE 802.1x Access Control
IEEE 802.1d Spanning Tree
IEEE 802.1w Rapid Spanning Tree
IEEE 802.3af Power over Ethernet
IEEE 802.3ad Link Aggregation Control Protocol (LACP)
RoHS Compliance
Physical Interface
Port 1-24 are 10/100Mbps Fast Ethernet ports.
Port 25,26 are Gigabit Combo SFP ports
RS-232 Consle port
Performance
Physical Interface
8 K MAC addresses
256k packet buffer and 128k control memory
The maximum throughput is 8.8Gbps
With 64 bytes packets throughput is 6.547Mpps
VSM (Virtual Stacking Management):
Up to 16 switches can be managed via Single IP Management
L2 Protocol
VLAN
Port-base VLAN
4K VLAN and up to 256 active VLANs included static plus
dynamic entry
In tag-base VLAN, supports egress/ingress packet filter
Q-in-Q is an efficient method for enabling Subscriber
Aggregation.
QoS
Supports Port Based, 802.1p , TOS and Diffserv(IPv4/IPv6) based
QoS packet classification
Supports four level priority queues to prioritize in-bound and
out-bound traffic
Supports two scheduling, WRR and Strict
Supports priority in a Q-in-Q tag
Broadcast Storm Protection
Multicast/Broadcast/Unknown-Unicast Storm suppression.
Port Mirroring
Support 1: N RX port mirroring.
Supports port sniffer function with 3 modes:
(TX Monitor Mode, RX Monitor Mode and TX-RX pair Monitor
Mode).
Isolated Group
Allows certain ports to be designated as protected.
Rate Limit
Ingress rate limit:
Port 1~24: 1K up to 100Mbps
Port 25, 26: 1K up to 1000Mbps
Egress rate limit:
Port 1~24: 1K up to 100Mbps
Port 25, 26: 1K up to 1000Mbps
PoE Specification
24 IEEE802.3af PoE PSE ports
Endpoint with 48VDC power through RJ-45 pin 1, 2, 3, 6.
PoE-PSE activity LED indicator.
380 watts full power supports (up to 15.4 watts for 24 ports)
Auto detect powered device and consumption levels
Supports per port power consumption monitoring
Smart feature for PD on/off, PD detection, power level, PD
status and power feeding priority
Circuit protection to prevent power interference between ports
Supports per port PoE State setting
Supports per port power priority setting
LACP
2 Fast Ethernet +1 Gigabit Ethernet groups
Per-group max 4 members
Provides DA, SA and DA+SA Mac-based trunking with
automatic link fail-over
GVRP/GARP
802.1q with GVRP/ GARP
Multicasting
Supports IGMP snooping including active and passive mode
STP/RSTP
802.1d/1w
Network Security
802.1x access control
Isolated group
Management Access Policy Control
Static MAC
MAC addresses learning limit
SNMP 1,v2c Network Management
RFC 1213 MIB (MIB-II)
Interface MIB
Address Translation MIB
IP MIB
ICMP MIB
TCP MIB
UDP MIB
SNMP MIB
RFC 1757 RMON MIB
Statistics Group 1
History Group 2
Alarm Group 3
Event Group 9
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB
Hardware Spec.
Power Voltage: 100~240 V, Frequency : 50~60 Hz
PoE Power Budge: Max. 380W
(with 24 x 15.4W PD device connected )
Ambient Temperature: 0°C to 40°C
Humidity: 5% to 90%
Dimensions 44(H) x 442(W) x 366(D) mm
Weight : 5.47kg