Hynix 8GB DDR3 PC3-10600 HMT41GU7MFR8C-H9 Benutzerhandbuch

Produktcode
HMT41GU7MFR8C-H9
Seite von 55
Rev. 1.0 / Jul. 2012
14 
Absolute Maximum Ratings
Absolute Maximum DC Ratings
Notes:
1. Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the 
device. This is a stress rating only and functional operation of the device at these or any other conditions above 
those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rat-
ing conditions for extended periods may affect reliability.
2. Storage Temperature is the case surface temperature on the center/top side of the DRAM. For the measurement 
conditions, please refer to JESD51-2 standard.
3. VDD and VDDQ must be within 300mV of each other at all times; and VREF must not be greater than 
0.6XVDDQ,When VDD and VDDQ are less than 500mV; VREF may be equal to or less than 300mV.
DRAM Component Operating Temperature Range
Notes:
1. Operating Temperature TOPER is the case surface temperature on the center / top side of the DRAM. For mea-
surement conditions, please refer to the JEDEC document JESD51-2.
2. The Normal Temperature Range specifies the temperatures where all DRAM specifications will be supported. Dur-
ing operation, the DRAM case temperature must be maintained between 0 - 85
o
C under all operating conditions.
3. Some applications require operation of the DRAM in the Extended Temperature Range between 85
o
C and 95
o
case temperature. Full specifications are guaranteed in this range, but the following additional conditions apply:
a. Refresh commands must be doubled in frequency, therefore reducing the Refresh interval tREFI to 3.9 µs. It 
is also possible to specify a component with 1X refresh (tREFI to 7.8µs) in the Extended Temperature Range. 
Please refer to the DIMM SPD for option availability
b. DDR3 SDRAMs support Auto Self-Refresh and Extended Temperature Range and please refer to component 
datasheet and/or the DIMM SPD for tREFI requirement in the Extended Temperature Range.
Absolute Maximum DC Ratings
Symbol
Parameter 
Rating
Units
Notes
 VDD
Voltage on VDD pin relative to Vss
- 0.4 V ~ 1.8 V
VDDQ  Voltage on VDDQ pin relative to Vss
- 0.4 V ~ 1.8 V
V
IN
, V
OUT
  Voltage on any pin relative to Vss
- 0.4 V ~ 1.8 V
1
T
STG
 
Storage Temperature 
-55 to +100
o
C
1,  2 
Temperature Range
Symbol
Parameter 
Rating
Units
Notes
 T
OPER
 Normal Operating Temperature Range
0 to 85
o
C 1,2
 Extended Temperature Range 
85 to 95
o
C
1,3