Star Micronics TSP654IIE3-24 39449770 Benutzerhandbuch
Produktcode
39449770
- 19 -
2
∼
3mm
4. Attaching the Accessories
The following accessories are necessary when mounting the printer to a wall.
• Holder plate and two flangeless screws
The following accessories are necessary when positioning the printer vertically.
• Four rubber feet
The following accessories do not necessarily have to be attached. Attach it if necessary.
• Switch cover
• Holder plate and two flangeless screws
The following accessories are necessary when positioning the printer vertically.
• Four rubber feet
The following accessories do not necessarily have to be attached. Attach it if necessary.
• Switch cover
4-1. Attaching the Holder Plate
<Precoutions>
n
The holder plate is attached to the printer using the included screws and is hooked onto screws that are installed
into the wall.
n
The screws on the wall are not included.
Use commercially available screws (4 mm diameter) that are suitable for the wall material (wood, steel beam,
concrete, etc.).
n
The printer’s weight is approximately 2.4 kg when the largest diameter roll paper is loaded.
Use screws on the wall that have both shear strength and pulling-out strength to withstand a force of at least
12 kgf (118 N).
(1) Attach the holding plate to the printer. Then tighten the two screws that were supplied to secure it in place.
(2) Position the printer over the screws, etc., on the wall and then slide it downward to set it in place.
After setting the printer in place, check the screws on the wall again to make sure that they are able to support the
printer’s weight.
printer’s weight.