Enterasys Platinum Distributed Forwarding Engine 7H4382-25 Benutzerhandbuch
Produktcode
7H4382-25
Unpacking the DFE-Platinum Module
3-2 Installation
Unpacking the DFE-Platinum Module
Unpack the DFE-Platinum module as follows:
1.
Open the box and remove the packing material protecting the DFE-Platinum module.
2.
Verify the contents of the carton as listed in
.
3.
Remove the tape seal on the non-conductive bag to remove the DFE-Platinum
module.
module.
4.
Perform a visual inspection of the DFE-Platinum module for any signs of physical
damage. Contact Enterasys Networks if there are any signs of damage. Refer to
damage. Contact Enterasys Networks if there are any signs of damage. Refer to
on page 1-6 for details.
Installing Optional Ethernet Interface Module
At the time of this printing, only the 7G-6MGBIC is available for the 7H4382-25. Refer to
your release notes for the latest available Ethernet interface modules. The 7G-6MGBIC
provides six Gigabit port slots for optional Mini-GBIC connections.
your release notes for the latest available Ethernet interface modules. The 7G-6MGBIC
provides six Gigabit port slots for optional Mini-GBIC connections.
Installing a 7G-6MGBIC involves
•
removing the coverplate from the DFE-Platinum module (7H4382-25),
•
attaching the 7G-6MGBIC to the DFE-Platinum module, and
•
installing the Mini-GBICs.
Table 3-2 Contents of DFE-Platinum Module Carton
Item
Quantity
DFE-Platinum module (7H4382-25)
1
Installation Guide
1
Customer Release Notes
1
Note: Install any optional equipment before proceeding to the section,
on page 3-8 for an explanation of the rules to install
different series modules in a Matrix E7 chassis.
Caution: An antistatic wrist strap is required to perform the following procedures to
minimize ESD damage to the devices involved.
minimize ESD damage to the devices involved.