Enterasys Platinum Distributed Forwarding Engine 7H4382-25 Benutzerhandbuch
Produktcode
7H4382-25
Installing an Optional Mini-GBIC
Matrix DFE-Series Module Installation Guide 3-7
Removing the Mini-GBIC
To remove a Mini-GBIC from a port slot, refer back to
and
, and
proceed as follows:
1.
Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap
package) before removing the Mini-GBIC.
package) before removing the Mini-GBIC.
2.
Remove the cables connected to the Mini-GBIC.
Figure 3-4 Mini-GBIC with LC Connector
1 Mini-GBIC
(MGBIC-LC01, MGBIC-LC09, MGBIC-08)
4 Port slot
2 Mini-GBIC
,
top side
5 Mini-GBIC
,
protective dust cover
3 7-Pin edge connector (insertion side)
6 Release tab
1
2
3
4
5
6
1
2
3
4
5
6
Ã
Â
Å
À
Á
Ä
Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab
located under the front bottom end of the Mini-GBIC
located under the front bottom end of the Mini-GBIC
.
This can damage the Mini-GBIC.
This is also true of the RJ45 Mini-GBICs with a wire handle. The handle must be pulled
down toward the bottom of the MINI-GBIC to release it.
down toward the bottom of the MINI-GBIC to release it.
The Mini-GBIC and its host device are sensitive to static discharges. Use an antistatic
wrist strap and observe all static precautions during this procedure. Failure to do so could
result in damaging the Mini-GBIC or host device. Always leave the Mini-GBIC in the
antistatic bag or an equivalent antistatic container when not installed.
wrist strap and observe all static precautions during this procedure. Failure to do so could
result in damaging the Mini-GBIC or host device. Always leave the Mini-GBIC in the
antistatic bag or an equivalent antistatic container when not installed.