Enterasys Platinum Distributed Forwarding Engine 7H4382-25 Benutzerhandbuch
Produktcode
7H4382-25
Memory Locations and Replacement Procedures
Matrix DFE Series Module Installation Guide B-7
DRAM SIMM Replacement Procedure
In the event that the DRAM Single In-line Memory Module (SIMM) needs to be replaced,
the following sections explain how to remove and install the SIMM. If you have questions
concerning the replacement of the SIMM, refer to the section,
the following sections explain how to remove and install the SIMM. If you have questions
concerning the replacement of the SIMM, refer to the section,
for details on how to contact Enterasys Networks.
Removing the DRAM SIMM
To remove the existing DRAM SIMM, proceed as follows:
1.
Locate the DRAM SIMM connector on the main PC board. Refer back to
the DRAM SIMM location on the 7H4382-25.
2.
Push the connector arms away from the DRAM SIMM, as shown in
simultaneously lift the DRAM SIMM enough to release it from the connector fingers.
3.
Rotate the DRAM SIMM upwards, then remove it from the connector fingers.
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Figure B-6 Removing the Existing DRAM SIMM
1 Connector arms
2 DRAM SIMM
3 Connector fingers
À
À
Á
Â