Intel E7-8891 v2 CM8063601377422 Benutzerhandbuch

Produktcode
CM8063601377422
Seite von 504
Intel
®
 Xeon
® 
Processor E7-2800/4800/8800 v2 Product Family
291
Datasheet Volume Two: Functional Description, February 2014
Integrated I/O (IIO) Configuration Registers
26:22
RV
-
Reserved  
21:21
RW
0x0
local_dft_event_select:
20:19
RW
0x0
event_group_selection:
Event Group Selection  
Selects which event register to use for performance monitoring.00: Bus events 
(XPMEVL,H register) and also Resource Utilizations (XP_PMER Registers) when 
all XP_PMEH and XP_PMEL Registers are set to ’0’. that is, When monitoring 
PMER events, all PMEV events are to be deselected; when monitoring PMEV 
events, all PMER events are to be deselected.
01: Reserved
10: Queue measurement (in the XPPMER register). Note: To enable FIFO 
queue histogramming write bit field CNTMD =’11’ and select queues in the 
XPPMER register.
11: Reserved 
18:17
RW
0x0
count_event_select:
Count Event Select  
Selects the condition for incrementing the performance monitor counter.
00: Event source selected by PMEV{L,H}
01: Partner event status (max compare or overflow)
10: All clocks when enabled
11: Reserved 
16:16
RW
0x0
event_polarity_invert:
Event Polarity Invert  
This bit inverts the polarity of the conditioned event signal.
0: No inversion
1: Invert the polarity of the conditioned event signal 
15:14
RW
0x0
count_mode:
Count Mode  
This field sets how the events will be counted.
00: Count clocks when event is logic high. Counting is level sensitive, 
whenever the event is logic 1 the counter is enabled to count.
01: Count rising edge events. Active low signals should be inverted with 
EVPOLINV for correct measurements.
10: Latch event and count clocks continuously. After the event is asserted, 
latch this state and count clocks continuously. The latched state of this 
condition is cleared by xxxPMRx.CNTRST bit, or PERFCON.GBRST, or GE[3:0].
11: Enable FIFO (push/pop) queue histogram measurement.
This mode will enable histogram measurements on PM0. This mode enable 
logic to perform the function listed in the table below. The measurement cycle 
will not begin until the Qempty signal is asserted. Refer to xref.
FIFO queue histogram table
FIFOn_Push.......FIFOn_POP............PMD Adder control
....0............................0........................Add zero
....1............................0........................Add queue bus value*
....0............................1........................Sub queue bus value*
....1............................1........................Add zero
The latched condition of the Qempty signal cannot be cleared by 
PMR.CLREVLAT. A new measurement cycle requires clearing all counters and 
the latched value by asserting either PMRx.CNTRST or PERFCON.GBRST. 
Type:
CFG
PortID:
N/A
Bus:
0
Device:
0Function:0
Bus:
0
Device:
2Function:0
Bus:
0
Device:
3Function:0
Offset:
0x494, 0x498
Bit
Attr
Default
Description