Zebra 30819 Benutzerhandbuch
3
Printer Diagnostics
In this section...
Page
Power ON Self Test ........................................................................3-1
Printer Self Tests .............................................................................3-2
Printer Self Tests .............................................................................3-2
Introduction................................................................................3-2
CANCEL key Self Test ............................................................3-3
PAUSE key Self Test ................................................................3-4
FEED key Self Test...................................................................3-5
Communications Diagnostics Test .........................................3-6
FEED key and PAUSE key ......................................................3-6
PAUSE key and CANCEL key................................................3-8
FEED key and CANCEL key ..................................................3-8
CANCEL key Self Test ............................................................3-3
PAUSE key Self Test ................................................................3-4
FEED key Self Test...................................................................3-5
Communications Diagnostics Test .........................................3-6
FEED key and PAUSE key ......................................................3-6
PAUSE key and CANCEL key................................................3-8
FEED key and CANCEL key ..................................................3-8
Extended Printer Diagnostics ........................................................3-9
PAUSE key Loopback Test ......................................................3-9
FEED key Loopback Test ........................................................3-10
FEED key Loopback Test ........................................................3-10
Test routines are built into the Zebra XiII Series Printers to aid the technician in
diagnosing faults. Some of these tests are enabled by pressing a front panel key
while turning the Printer Power Switch ON.
diagnosing faults. Some of these tests are enabled by pressing a front panel key
while turning the Printer Power Switch ON.
Power On Self Test
A Power ON Self Test (POST) is performed each time the Printer is turned ON.
This test checks for proper initialization of various electronic circuits and
establishes starting parameters as those stored in the printer’s memory. During
this test sequence, the front panel LEDs will turn ON and OFF to insure proper
operation.
This test checks for proper initialization of various electronic circuits and
establishes starting parameters as those stored in the printer’s memory. During
this test sequence, the front panel LEDs will turn ON and OFF to insure proper
operation.
At the end of this Self Test, only the POWER LED will remain lit. If other LEDs
are also lit, refer to Section 6 (Troubleshooting) in this manual.
are also lit, refer to Section 6 (Troubleshooting) in this manual.
If the printer is set up for non-continuous media, one or more labels will feed
out, up to a maximum length of one label plus three additional inches of media.
out, up to a maximum length of one label plus three additional inches of media.
To initiate the Power On Self Test (POST), turn the Printer ON using the Power
Switch in the rear. The front panel Power On indicator will light. The other front
panel LEDs and the Liquid Crystal Display (LCD) monitor the progress and
indicate the results of the Self Test. The normal Self Test sequence is shown on
the following page.
Switch in the rear. The front panel Power On indicator will light. The other front
panel LEDs and the Liquid Crystal Display (LCD) monitor the progress and
indicate the results of the Self Test. The normal Self Test sequence is shown on
the following page.
48452L Rev. 2
XiII-Series Maintenance Manual
Page 3-1