Zebra 30819 Benutzerhandbuch
6
Troubleshooting
In this section...
Page
Basic Troubleshooting.......................................................................6-1
Troubleshooting Charts .....................................................................6-1
Sample Labels ...................................................................................6-7
Factory Assistance.............................................................................6-14
Returning Equipment ........................................................................6-14
Troubleshooting Charts .....................................................................6-1
Sample Labels ...................................................................................6-7
Factory Assistance.............................................................................6-14
Returning Equipment ........................................................................6-14
Basic Troubleshooting
Consult the Troubleshooting Tables which follow and compare the printer
output to the sample labels provided on the following pages to improve the
quality of your labels.
output to the sample labels provided on the following pages to improve the
quality of your labels.
Troubleshooting Charts
SYMPTOM
DIAGNOSIS
ACTION
All LEDs light,
but nothing
displays on LCD
and printer will
not operate.
but nothing
displays on LCD
and printer will
not operate.
Main Logic Board
or Program ROM faulty.
or Program ROM faulty.
Insure Program ROMs are
properly installed or Replace
the Main Logic Board.
properly installed or Replace
the Main Logic Board.
All LEDs Flash
ON and OFF.
ON and OFF.
No significant amount of
DRAM tested good.
DRAM tested good.
Replace the
Main Logic Board.
Main Logic Board.
Take Label LED
Flashing.
Flashing.
Printer misconfigured for
Peel-Off Mode.
Peel-Off Mode.
If Peel-Off is desired, check
Take Label Sensor.
Take Label Sensor.
Printer locks up
while running
Power On
Self Test.
while running
Power On
Self Test.
Main Logic Board failure.
Replace Main Logic Board.
CHECKSUM FOR ROM
SET n INVALID
A Program ROM checksum
is incorrect.
is incorrect.
Turn the printer OFF and then
ON. If the fault reoccurs, replace
the Program ROMs.
ON. If the fault reoccurs, replace
the Program ROMs.
EEPROM CHECKSUM
INVALID
EEPROM checksum
is incorrect.
is incorrect.
Replace the
Main Logic Board.
Main Logic Board.
Table 6.1
Power On Troubleshooting
48452L Rev. 2
XiII-Series Maintenance Manual
Page 6-1