Cisco FactoryUpgrade 8MB DRAM to 12MB 800Series (B) MEM800-8U12D Benutzerhandbuch

78-10446-01

This is the name of the image file on the router—not the full pathname of the image on the CD-ROM
attached to the PC. Refer to Table 4 in the “Cisco 800 Series Routers Feature Packs” section on page 5
for the UNIX image filename.

Destination file name [aaa1167.bin.bin]? c800-nsy6-l

During the transfer process, the software displays messages indicating that it has accessed the file you
have specified and is loading it.

At the prompt, enter yes if you want to erase the existing image copy resident in the router Flash
memory before copying the new one.

Erase flash device before writing? [confirm]

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each exclamation point (!)
indicates that ten packets have been transferred successfully. A checksum verification of the image
occurs after the image is written to Flash memory.

Enter the reload command to reload the router:

Router# reload

After the reload is complete, the router should be running the required Cisco IOS image. Use the
show version command to verify it.

The Common Application Programming Interface (CAPI) is an application programming interface
standard used to access ISDN equipment connected to Basic Rate Interfaces (BRIs) and Primary Rate
Interfaces (PRIs). Remote Common Application Programming Interface (RCAPI) is the CAPI feature
configured remotely from a PC client. CAPI provides the following features:

A standardized interface through which application programs use ISDN drivers and controllers.
One application can use one or more controllers. Several applications can share one or more
controllers.

A selection mechanism that supports applications that use protocols at different levels and
standardized network access. To provide this support, an abstraction from different protocol
variables is performed. All connection-related data, such as connection state and display messages,
is available to the applications at any time.