Lancom Systems 1781VA-4G 62042 Benutzerhandbuch

LTE, UMTS, HSPA, Edge and GPRS support (mode of transmission automatically or manually adjustable)

Supported standards

800/900/1800/2100/2600 MHz (automatically or manually adjustable)

LTE-bands

900/2100 MHz

UMTS and HSPA bands

850/900/1800/1900 MHz

EDGE/GPRS bands

+24 dBm

Maximum transmission power UMTS/HSxPA

Receive diversity on the aux antenna (2G + 3G); MIMO (2x2) for LTE (4G)

Diversity support

Mini-SIM (2FF), Micro-SIM (3FF) via adaptor, Nano-SIM (4FF) via adaptor

Supported SIM card formats

Is supported

Dual-SIM support

Is supported

Multi-SIM support

Changing of SIM pin via LANconfig or CLI (command line interface)

SIM pin

Incoming/Outgoing Traffic inspection based on connection information. Trigger for firewall rules depending on backup status, e.g. simplified rule
sets for low-bandwidth backup lines. Limitation of the number of sessions per remote site (ID)

Stateful inspection firewall

Check based on the header information of an IP packet (IP or MAC source/destination addresses; source/destination ports, DiffServ attribute);
remote-site dependant, direction dependant, bandwidth dependant

Packet filter

Network Address Translation (NAT) based on protocol and WAN address, i.e. to make internal webservers accessible from WAN

Extended port forwarding

N:N IP address mapping for translation of IP addresses or entire networks

N:N IP address mapping

The firewall marks packets with routing tags, e.g. for policy-based routing; Source routing tags for the creation of independent firewall rules for
different ARF contexts

Tagging

Forward, drop, reject, block sender address, close destination port, disconnect

Actions

Via e-mail, SYSLOG or SNMP trap

Notification

Dynamic bandwidth management with IP traffic shaping

Traffic shaping

Dynamic reservation of minimum and maximum bandwidths, totally or connection based, separate settings for send and receive directions. Setting
relative bandwidth limits for QoS in percent

Bandwidth reservation

Priority queuing of packets based on DiffServ/TOS fields

DiffServ/TOS

Automatic packet-size control by fragmentation or Path Maximum Transmission Unit (PMTU) adjustment

Packet-size control

Automatic or fixed translation of layer-2 priority information (IEEE 802.11p-marked Ethernet frames) to layer-3 DiffServ attributes in routing mode.
Translation from layer 3 to layer 2 with automatic recognition of IEEE 802.11p-support in the destination device

Layer 2/Layer 3 tagging

Monitoring and blocking of login attempts and port scans

Intrusion Prevention

Source IP address check on all interfaces: only IP addresses belonging to the defined IP networks are allowed

IP spoofing

Filtering of IP or MAC addresses and preset protocols for configuration access and LANCAPI

Access control lists

Protection from fragmentation errors and SYN flooding

Denial of Service protection

Detailed settings for handling reassembly, PING, stealth mode and AUTH port

General

Filtering of unwanted URLs based on DNS hitlists and wildcard filters. Extended functionality with Content Filter Option

URL blocker

Password-protected configuration access can be set for each interface

Password protection

Alerts via e-mail, SNMP-Traps and SYSLOG

Alerts

PAP, CHAP, MS-CHAP and MS-CHAPv2 as PPP authentication mechanism

Authentication mechanisms

Anti-theft ISDN site verification over B or D channel (self-initiated call back and blocking)

Anti-theft

Network protection via site verification by GPS positioning, device stops operating if its location is changes

GPS anti-theft

Adjustable reset button for 'ignore', 'boot-only' and 'reset-or-boot'

Adjustable reset button

LANCOM 1781VA-4G

Features as of: LCOS 9.00