Gigaset A230 S30852-H2413-D201 Benutzerhandbuch
Produktcode
S30852-H2413-D201
Lombok A130/AL130A/A230/AL230A / Großbritannien / A31008-M2412-L101-1-7619 / Lombok.fm / 12.02.2013
V
e
rsi
on 4
, 16.09
.2005
6
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged
and discharged.
and discharged.
Warning
Use only the rechargeable batteries recommended by Gigaset Communications
GmbH (
GmbH (
page 13), i.e. never use conventional (non-rechargeable) batteries as
this could result in significant health risks and personal injury. For example, the
batteries could explode. The phone could also malfunction or be damaged as a
result of using batteries that are not of the recommended type.
batteries could explode. The phone could also malfunction or be damaged as a
result of using batteries that are not of the recommended type.
¤
Insert the batteries with
the polarity in the correct
direction.
the polarity in the correct
direction.
The polarity is indicated in the
battery compartment.
battery compartment.
¤
First insert the battery cover at the top
a
.
¤
Then press the cover
b
until it clicks into
place.
¤
To reopen the battery cover, grip into the
cavity on the casing, then pull the battery
cover in an upward direction.
cavity on the casing, then pull the battery
cover in an upward direction.
a
b
6.5
h
¤
Charge the handset in the base for 6.5 hours.
¤
After charging the handset for the first time, remove the handset
from the base and only replace it when the batteries are fully
discharged.
from the base and only replace it when the batteries are fully
discharged.
Please note
The handset must only be placed in the designated Gigaset base
or charging cradle.
or charging cradle.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming
calls, and so that the alarm can be used.
calls, and so that the alarm can be used.
MENU
¤
u
Settings
¤
OK
¤
Date/Time
¤
OK
¤
Date
¤
~
(enter the day, month
and year in 6-digit format)
¤
OK
¤
Time
¤
~
(enter hours and minutes in 4-digit
format)
¤
OK (display message: Saved)
¤
a
(press and hold to return to idle status)
When entering the time and date, you can move the position of an entry to the left or
right by pressing the control key
right by pressing the control key
u
up or down.
Please note
◆
The handset is pre-registered with the base. If you have purchased a
model with multiple handsets, all handsets will already be registered
with the base. You do not need to register the handset again. The internal
handset number appears in the top left of the display, e.g. 1 (
model with multiple handsets, all handsets will already be registered
with the base. You do not need to register the handset again. The internal
handset number appears in the top left of the display, e.g. 1 (
However, if a handset is not registered with the base (Register HS or Put
into base is displayed), please register the handset manually (
into base is displayed), please register the handset manually (
◆
If you have purchased multiple devices, you can upgrade your Gigaset to
a cordless PABX by registering all A130/A230 handsets at the same base
(
a cordless PABX by registering all A130/A230 handsets at the same base
(
◆
After the first battery charge and discharge, you may place your handset
in the charger after every call.
in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
batteries from the handset and reinsert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for techni-
cal reasons.
cal reasons.