Greisinger T-Log 100 Temperature Data Logger 600681 Datenbogen

E39.0.0X.6C-03                                               Operating instruction T-Logg 100 and T-Logg 100 E                                                                page 5 of 6

Notice:
As soon as 

 appears at display, the battery needs to be replaced. If battery voltage power decreases

continuously, data logging will be stopped (compare with operating status ‘

HALT

’).

Available stored data remains in the memory and do not get lost. It’s possible to read the measuring data after
replacement of the battery.

1.  Remove the 4 screws at the front of the logger with a

small screwdriver and remove the cover from housing.

2.  Take out the PCB and deposit it carefully beside the

housing with the LCD display face down. Take care not
to damage the gasket.

3.  Push out the button cell carefully from socket (see

picture at the top on the right).

4.  Insert the new button cell (type CR 2032) with correct

polarity in the socket (the positive pole is on the retaining
bracket – see picture at the bottom on the right).

5.  Reinsert the PCB correctly (LCD face up) into the

housing (see picture in the middle on the right).

6.  Reassemble the housing. Use the 4 screws to fix the

cover again.

Environmental Reference! Empty and defective batteries must not be disposed in the

regular domestic waste.
Return the used batteries to an authorised battery
collecting point or send the batteries directly to us
(sufficiently stamped).