Gossen Metrawatt M817S Mains-analysis device, Mains analyser M817S Datenbogen
Produktcode
M817S
2-1
C H A P T E R 2
Voltage Measurement Cable and Current Probe Connections
Overview
Introduction
This section describes how to connect the Energy Platform to make basic single phase
voltage measurements. For multi-phase connection diagrams, refer to Appendix E.
In this chapter
The following topics are covered in this c
hapter.
WARNING
Death, serious injury, or fire hazard could result from improper connection of this
instrument. Read and understand this manual before connecting this instrument.
Follow all installation and operating instructions while using this instrument.
instrument. Read and understand this manual before connecting this instrument.
Follow all installation and operating instructions while using this instrument.
Connection of this instrument must be performed in compliance with the National
Electrical Code (ANSI/NFPA 70-2008) and any additional safety requirements
applicable to your installation.
Electrical Code (ANSI/NFPA 70-2008) and any additional safety requirements
applicable to your installation.
Installation, operation, and maintenance of this instrument must be performed by
qualified personnel only. The National Electrical Code defines a qualified person
as “one who has the skills and knowledge related to the construction and
operation of the electrical equipment and installations, and who has received
safety training on the hazards involved.”
qualified personnel only. The National Electrical Code defines a qualified person
as “one who has the skills and knowledge related to the construction and
operation of the electrical equipment and installations, and who has received
safety training on the hazards involved.”
Qualified personnel who work on or near exposed energized electrical conductors
must follow applicable safety related work practices and procedures including
appropriate personal protective equipment in compliance with the Standard for
Electrical Safety Requirements for Employee Workplaces (ANSI/NFPA 70E-2009)
of USA and any additional workplace safety requirements applicable to your
installation.
must follow applicable safety related work practices and procedures including
appropriate personal protective equipment in compliance with the Standard for
Electrical Safety Requirements for Employee Workplaces (ANSI/NFPA 70E-2009)
of USA and any additional workplace safety requirements applicable to your
installation.
Continued on next page
Topic
See Page
Connecting Voltage Measurement Cables
2-4
Connecting Current Probes
2-9