TE Connectivity Connector pin AWG (min.): 28 AWG max.: 24 Gold plated 166294-1 1 pc(s) 166294-1 Informationshandbuch
Produktcode
166294-1
Product
Specification
Specification
108-40005
11Mar11 Rev F
AMPLIMITE* HDP-20 Subminiature D Connector With F Crimp
Contacts
Contacts
1.
SCOPE
1.1.
Content
This specification covers the perform ance, test and quality requirem ents for the AMPLIMITE* HDP-20
subm iniature D connectors with rem ovable F crim p contacts. The assem bly consists of a two piece
plastic housing which has integral plastic retention tines and two m etal shells which secure the housing
com ponents.
subm iniature D connectors with rem ovable F crim p contacts. The assem bly consists of a two piece
plastic housing which has integral plastic retention tines and two m etal shells which secure the housing
com ponents.
1.2.
Qualification
W hen tests are perform ed on the subject product line, the procedures specified in Figure 1 shall be
used. All inspections shall be perform ed using the applicable inspection plan and product drawing.
used. All inspections shall be perform ed using the applicable inspection plan and product drawing.
1.3.
Qualification Test Results
Successful qualification testing on the subject product line was com pleted on 06Oct89. The
Qualification Test Report num ber for this testing is 501-99. This docum entation is on file at and
available from Engineering Practices and Standards (EPS).
Qualification Test Report num ber for this testing is 501-99. This docum entation is on file at and
available from Engineering Practices and Standards (EPS).
2.
APPLICABLE DOCUM ENTS
The following docum ents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the docum ent applies. In the event of conflict between the
requirem ents of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirem ents of this specification and the referenced docum ents,
this specification shall take precedence.
otherwise specified, the latest edition of the docum ent applies. In the event of conflict between the
requirem ents of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirem ents of this specification and the referenced docum ents,
this specification shall take precedence.
2.1.
TE Connectivity (TE) Docum ents
!
114-40030: Application Specification (AMPLIMITE* HDP-20 & Econom y Crim p Snap
Subm iniature D Com m ercial Connectors)
Subm iniature D Com m ercial Connectors)
!
501-99: Qualification Test Report (AMPLIMITE* HDP-20 Subm iniature D Connector W ith F Crim p
Contacts)
Contacts)
2.2.
Industry Standard
EIA-364: Electrical Connector/Socket Test Procedures Including Environm ental Classifications
2.3.
Reference Docum ent
109-197: Test Specification (AMP Test Specifications vs EIA and IEC Test Methods)
3.
REQUIREM ENTS
3.1.
Design and Construction
Product shall be of the design, construction and physical dim ensions specified on the applicable product
drawing.
drawing.
©2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. Company
All Rights Reserved
a TE Connectivity Ltd. Company
All Rights Reserved
| Indicates change
*Trademark
*Trademark
For latest revision, visit our website at www.te.com/documents.
For Regional Customer Service, visit our website at www.te.com
For Regional Customer Service, visit our website at www.te.com
1 of 10
TE logo is a trademark.
Other products, logos, and company names might be trademarks of their respective owners.
LOC B