Mediola FS20 Wireless master slave transmitter 1-channel Max. range (open field) 100 m 1057-97 Datenbogen
Produktcode
1057-97
12
a) Addressing the receiver
If you wish to use the basic settings of the ‘FS20 FMS’, proceed as follows
(otherwise see the sections near the end of this manual!):
• Place the corresponding receiver in the mode in which it can receive
(otherwise see the sections near the end of this manual!):
• Place the corresponding receiver in the mode in which it can receive
addressing data (for a wireless switch socket ‘FS20 ST’ you must press
and hold its control button for more than 15 seconds, until the LED
begins to blink).
and hold its control button for more than 15 seconds, until the LED
begins to blink).
• Briefly press the control button of the ‘FS20 FMS’.
• The receiver (for instance, the ‘FS20 ST’) confirms the reception (status
indicator stops blinking or goes out).
b) Manual switching
• Briefly pressing the button on the ‘FS20 FMS’ transmits a TOGGLE
command (switching back to the previous switch status).
• The slave device is turned on or off.
c) Switching via the master device
• Turn the master device on (power consumption of at least approx.
4.6W!). The ‘FS20 FMS’ recognises this and sends a switching com-
mand. The slave device turns on.
mand. The slave device turns on.
• Turn the master device off. The slave device also turns off.
You can now use the basic functions of the system. Please
also read the following sections, if you require an extended
system with several components or you wish to use the
additional functions.
also read the following sections, if you require an extended
system with several components or you wish to use the
additional functions.