Renkforce Digitale Funk-Wetterstation sw Wireless Weather Station E0303H2TPR Datenbogen
Produktcode
E0303H2TPR
36
9. Installation/Setup
Before firmly installing the outdoor sensor and the weather station, ensure that
the weather station receives the radio signal of the outdoor sensor without
problems.
• The outdoor sensor can be attached to the wall on a nail, screw or hook using an opening
(13) on the rear. Alternatively, a setup base can be unfolded (12) at the bottom.
The outdoor sensor is suitable to be used in a protected outdoor area. It should be
placed so that it is not subject to direct solar irradiation, because the measured values
will be incorrect otherwise. Precipitation on the outdoor sensor also leads to incorrect
temperature measurement because the casing cools off. Never immerse or submerge
the outdoor sensor in water; it would be destroyed!
We therefore recommend careful selection of the site of set-up for the outdoor sensor
to measure the correct temperature (and humidity).
• The weather station can be attached to the wall by two openings (1) using two nails/
screws, hooks (hole distance 132 mm).
An unfolding standing base (6) can be used to set up the weather station on a level,
stable surface. Protect valuable furniture surfaces from scratches with suitable
pads.
Select a location as operating site that is not in the sun or next to a radiator. This will
falsify the temperature or humidity display.