Gw Instek USG-0103 Function Generator, Frequency Generator USG-0103 Datenbogen
Produktcode
USG-0103
GETTING STARTED
13
Function Settings
Chooses the type of function to be performed by
the USG: Continuous Sweep, Single Sweep, Single
Point or Hopping.
the USG: Continuous Sweep, Single Sweep, Single
Point or Hopping.
Frequency Range
Settings
Settings
Sets the basic start and stop frequency parameter
settings. It also displays the instantaneous
(current) output frequency, as shown below.
settings. It also displays the instantaneous
(current) output frequency, as shown below.
Start frequency
Stop frequency
Actual frequency
Frequency Status
Bar
Bar
When the output is on, the point on the frequency
status bar indicates the instantaneous frequency
that is being output. When the output is off, the
status bar can set the start and stop frequencies.
status bar indicates the instantaneous frequency
that is being output. When the output is off, the
status bar can set the start and stop frequencies.
Start key
Pressing Start will output the selected function.
About
Pressing About will display the GNU lesser GPL
license requirements.
license requirements.
To Main panel
Indicates that swiping to the right will go to the
Main panel.
Main panel.
Frequency Setting
panel
panel
Indicates that the interface is in the Frequency
Setting panel.
Setting panel.
Frequency Offset
Settings
Settings
Offsets the frequency by ±50 kHz.
Power Sweep
Settings
Settings
Sets the start and stop power level settings. The
From setting sets the initial power level at the start
of the sweep, and the To setting sets the final
power level at the end of the sweep.
From setting sets the initial power level at the start
of the sweep, and the To setting sets the final
power level at the end of the sweep.