Zoom H2N Benutzerhandbuch
Preparation
Po
w
ering the recorder
12
Preparation
Inst
alling an SD card
alling an SD card
13
H2n
Handy Recorder
NOTE
∙ Use alkaline or nickel-metal hydride batteries.
∙ If the “Low battery!” warning appears, turn the power OFF
∙ If the “Low battery!” warning appears, turn the power OFF
soon and put in new batteries.
∙ Set the type of battery used. (➝P.18)
Preparation
Powering the recorder
1.
Turn the power OFF, and then remove the battery cover.
1.
Connect the cable to the USB port.
3.
Close the cover.
2.
Insert batteries.
2.
Plug the adapter into a power outlet.
Using batteries
Using an AC adapter (sold separately)
Press here
and slide down
and slide down
Installing an SD card
1.
After turning the power OFF, open the SD card slot cover.
2.
Insert the card into the slot.
To remove a card, push it further into
the slot and then pull it out.
the slot and then pull it out.
HINT
Built-in memory
∙ The built-in memory only keeps the most recent recording.
∙ The recording format is fi xed at 96kbps MP3.
∙ It cannot be used to record in 4ch surround or MS-RAW modes.
∙ Recording time is limited to 1 minute.
∙ Recordings saved to the built-in memory cannot be copied to an SD card or a
∙ The built-in memory only keeps the most recent recording.
∙ The recording format is fi xed at 96kbps MP3.
∙ It cannot be used to record in 4ch surround or MS-RAW modes.
∙ Recording time is limited to 1 minute.
∙ Recordings saved to the built-in memory cannot be copied to an SD card or a
computer.
NOTE
∙ Always turn the power OFF before inserting or removing an SD card. Doing so
when the power is ON could cause data to be lost.
∙ Be sure to insert the SD card correctly, using the cut-off corner illustration next
to the slot as a guide.
∙ The built-in memory will be used if no SD card is in the recorder.
∙ Format the SD card if necessary. (➝ P.83)
∙ Format the SD card if necessary. (➝ P.83)