Rc Logger 89061RC Datenbogen
For PPM
The following requirements are needed if you intend to make use of the Xtreme's PPM feature:
- You need to provide PPM receiver (not PWM!) with a true PPM output port.
- Best are 7 available channels (6 are good as well - channel 7 can be ignored as it is only used for
external trigger) on your transmitter.
- Best are 2x 3-way(*) switch and 1x 2-way switch available on your transmitter.
*: A 2-way switch will work too considering the assumption that "end points" can be shifted with your
transmitter.
Teaching and set-up procedure is very similar for various radios. The differences depend on your radio /
receiver model set-up options and features.
If your radio does not support PPM receivers you may still make use of the
- You need to provide PPM receiver (not PWM!) with a true PPM output port.
- Best are 7 available channels (6 are good as well - channel 7 can be ignored as it is only used for
external trigger) on your transmitter.
- Best are 2x 3-way(*) switch and 1x 2-way switch available on your transmitter.
*: A 2-way switch will work too considering the assumption that "end points" can be shifted with your
transmitter.
Teaching and set-up procedure is very similar for various radios. The differences depend on your radio /
receiver model set-up options and features.
If your radio does not support PPM receivers you may still make use of the
OneLINK
to work with your
system.
For OneLINK
For OneLINK
The following requirements are needed if you intend to make use of the OneLINK connected to your own
transmitter:
- Your transmitter provides a trainer port with PPM signal out.
- Best are 7 available channels (6 are good as well - channel 7 can be ignored as it is only used for
external trigger) on your transmitter.
We directly support major brands by providing pre-prepared trainer port/OneLINK cables for these
transmitter sets. Additional information concerning trainer port pin
assignment and guidelines on retrieving the PPM signal can be found here:
transmitter:
- Your transmitter provides a trainer port with PPM signal out.
- Best are 7 available channels (6 are good as well - channel 7 can be ignored as it is only used for
external trigger) on your transmitter.
We directly support major brands by providing pre-prepared trainer port/OneLINK cables for these
transmitter sets. Additional information concerning trainer port pin
assignment and guidelines on retrieving the PPM signal can be found here:
http://users.belgacom.net/TX2TX/tx2tx/english/tx2txgb7.htm
(With courtesy of
ALBATROS
)
In general, the frequency of your existing transmitter does not affect the compatibility with the OneLINK
system.