H Tronic 230 V / ACCharger C5ForNiCd, NiMH, Li-ion, LiPolymer, SLA, Lead-acid, Lead acid membraneRechargeable batteriesM 1242465 Benutzerhandbuch
Produktcode
1242465
• Select a stable, sufficiently large and flat surface location. Otherwise, there is a danger of injury due to the
weight of the product should it fall off. Moreover, the unit will be damaged.
Never place the charger and battery on inflammable surfaces (e.g. carpets). Make sure that no easily
inflammable items (cloths, cotton waste or similar) are next to the unit. Also ensure that the mains and
charging leads are on non-flammable surfaces and not next to easily inflammable items or surfaces. If
necessary, use a suitable non-flammable base (e.g. a large, thick porcelain tile or stone slab).
charging leads are on non-flammable surfaces and not next to easily inflammable items or surfaces. If
necessary, use a suitable non-flammable base (e.g. a large, thick porcelain tile or stone slab).
• Ensure sufficient ventilation during the operation phase; never cover the charger or the connected battery.
Leave a sufficient gap (min. 5-10cm) between the charger and surroundings/wall to enable adequate air
circulation.
circulation.
• Never connect the product to the mains supply immediately after it has been brought from a cold room into a
warm room. Under certain circumstances the resultant condensation can lead to malfunction or damages
and, moreover, there is a danger of electric shock.
and, moreover, there is a danger of electric shock.
First allow the charger (and the battery/batteries) to equilibrate to room temperature prior to
connecting the charger to the mains supply and operating it. This can take several hours!
• Service, adjustment or repair work may only be carried out by specialists/specialist workshops. There are no
product parts within the unit which may be serviced or adjusted by you.
• In commercial establishments the accident prevention regulations of the Health and Safety Executive (HSE)
are to be observed.
• In schools, educational establishments, hobby and self-help workshops the operation of this product is to be
overseen by trained personnel.
• Handle the product carefully; it will be damaged by blows, knocks or a fall from even a short height.
Should you not be entirely clear about the correct connection or operation, or should any questions arise, the
answers to which are not covered by the operating instructions, then please contact our technical information
office or another specialist.
office or another specialist.
• Operation is only permissible in dry, closed interiors. The charger (and a connected battery/battery pack) must
not be allowed to become damp or wet.
• Place the charger on an even, solid and non-flammable surface. This must be large enough so that the
connected battery/battery pack can be placed safely alongside it.
The battery must not be placed on top or under the charger!
Although the charger is equipped with numerous safety functions, excessive heating of the battery can never be
completely excluded. The use of charging cables which are too thin or connection problems which occur, can
also lead to dangerous operating conditions.
also lead to dangerous operating conditions.
Do not place the charger on valuable furniture surfaces (not even for storage when not in use); chemical
reactions can otherwise cause discolouration due to the rubber feet, moreover, impressions may result. Use
a suitable base.
a suitable base.
• Pay attention when setting up the charger that neither the mains cable nor the battery charging cable
becomes bent or squashed. Place the charger, battery and cables in such a way that no one can trip over
them.
them.
• Never operate the charger unattended!
• Avoid the following adverse environmental conditions at the site of operation or during transport:
Strong or direct sunlight
Strong or direct sunlight
Wetness or too high a humidity
Extreme cold (<0°C) or heat (>35°C)
Extreme cold (<0°C) or heat (>35°C)
Dust or inflammable gases, steam or solvents, strong vibrations, strong magnetic fields
(such as occur near machines or loudspeakers)
(such as occur near machines or loudspeakers)
Handling