Ryobi RBV3000CESV Mains- 5133002190 Datenbogen

Produktcode
5133002190
Seite von 24
1
 WARNING
When using the product, the safety rules must be 
followed. For your own safety and that of bystanders, you 
must read and fully understand these instructions before 
operating the product. Please keep these instructions 
safe for later use.
 WARNING
This power tool is not intended to be used by children 
or persons with reduced physical, mental or sensory 
capabilities. Children should be adequately supervised 
to ensure they do not play with the power tool.
GENERAL SAFETY WARNINGS
TRAINING
 
Ŷ
Read the instructions carefully. Be familiar with the 
controls and the correct use of the product.
 
Ŷ
Never allow children, persons with reduced physical, 
sensory or mental capabilities or lack of experience and 
knowledge or people unfamiliar with these instructions 
to use the product. Local regulations may restrict the 
age of the operator.
 
Ŷ
Keep in mind, that the operator or user is responsible 
for accidents or hazards occurring to other people or 
their property.
 
Ŷ
Keep bystanders, children and pets 15 m away from 
the area of operation. Stop the product if anyone enters 
the area.
 
Ŷ
Never use the product when you are tired, ill or under 
the influence of alcohol, drugs or medicine.
ELECTRICAL SAFETY
 
Ŷ
Power plugs must match the outlet. Never modify the 
plug in any way. Do not use any adapter plugs with 
earthed (grounded) power tools. Unmodified plugs and 
matching outlets will reduce risk of electric shock.
 
Ŷ
Avoid unintentional starting. Always check that the 
switch is in the Off position before plugging in the 
product to the power supply. Do not carry a plugged in 
product with your finger on the switch.
 
Ŷ
Avoid body contact with earthed or grounded surfaces, 
such as pipes, radiators, ranges and refrigerators. 
There is an increased risk of electric shock if your body 
is earthed or grounded.
 
Ŷ
Do not expose this product to rain or wet conditions. 
Water entering an appliance will increase the risk of 
electric shock.
 
Ŷ
Electrical power should be supplied via a residual 
current device (RCD) with a tripping current of not more 
than 30 mA.
 
Ŷ
Before every use, examine the power cord for damage. 
If there are signs of damage, it must be replaced by at 
an authorised service centre. Always uncoil the power 
cord during use; coiled cables can overheat.
 
Ŷ
If you need to use an extension cord ensure it is suitable 
for outdoor use and has a current capacity rating 
sufficient to supply your tool. The extension cord cable 
should be marked with either “H05 RN F” or “H05 VV F”. 
Check the extension cord before every use for damage. 
Always uncoil the extension cord during use because 
coiled cords can overheat. Damaged extension cords 
should not be repaired, they should be replaced with 
an equivalent type.
 
Ŷ
Make sure the power cord is positioned so that it will not 
be stepped on, tripped over or otherwise subjected to 
damage or stress.
 
Ŷ
Never pick up or carry the product by the electric cable.
 
Ŷ
Never pull by the power cord to disconnect from the 
power supply.
 
Ŷ
Keep the power cord away from heat, oil and sharp 
edges.
 
Ŷ
Always direct the cable to the rear away from the 
machine.
 
Ŷ
Make sure voltage is correct for your product. A 
nameplate on the product indicates the unit’s voltage. 
Never connect the product to an AC voltage that differs 
from this voltage.
 
Ŷ
Make sure the switch is in Off position before 
disconnecting from power supply.
PREPARATION
 
Ŷ
Some regions have regulations that restrict the use of 
the product to some operations. Check with your local 
authority for advice.
 
Ŷ
While operating the product always wear substantial 
footwear and long trousers. Do not operate the product 
when barefoot or wearing open sandals. Avoid wearing 
clothing that is loose fitting or that has hanging cords or 
ties; they can be caught in moving parts.
 
Ŷ
Do not wear loose clothing or jewellery that can be 
drawn into the air inlet.
 
Ŷ
Secure long hair so it is above shoulder level to prevent 
entanglement in moving parts.
 
Ŷ
Wear hearing protection at all times whilst operating the 
product. This product is extremely noisy and permanent 
hearing may result if precautions to limit your exposure, 
reduce noise and wear hearing protection are not 
strictly adhered to.
 
Ŷ
Wear full eye protection at all times whilst operating this 
product. The manufacturer strongly suggests a full face 
mask or fully enclosed goggles. Normal spectacles or 
sun glasses are not adequate protection. Objects can 
be thrown at high speed by the powerful air jet at any 
time and may rebound from hard surfaces toward the 
operator.
 
Ŷ
Ensure before each use that all controls and safety 
devices function correctly. Do not use the tool if the “off” 
switch does not stop the product.
 
Ŷ
Before each use, always visually inspect to see, that the 
housing is undamaged and that guards and handles are 
in place and properly secured.
 
Ŷ
Return to an authorised service centre to replace 
damaged or unreadable labels.
 
Ŷ
Never operate the appliance with defective guards or 
shields, or without safety devices, for example debris