Texas Instruments LM3448 Evaluation Board LM3448-EDSNEV/NOPB LM3448-EDSNEV/NOPB Datenbogen
Produktcode
LM3448-EDSNEV/NOPB
1
4
3
2
16
13
14
15
ASNS
DIM
GND
FLTR1
COFF
FLTR2
5
12
BLDR
ISNS
11
NC
NC
VCC
GND
10
8
9
SW
SW
6
7
SW
SW
SNOSB51C – SEPTEMBER 2011 – REVISED MAY 2013
Connection Diagram
Top View
Figure 2. 16-Lead Narrow SOIC Package
PIN DESCRIPTIONS
Pin(s)
Name
Description
1, 2, 15,
SW
Drain connection of internal 600V MOSFET.
16
3, 14
NC
No connect. Provides clearance between high voltage and low voltage pins. Do not tie to GND.
4
BLDR
Bleeder pin. Provides the input signal to the angle detect circuitry. A 230
Ω
internal resistor ensures BLDR is pulled
down for proper angle sense detection.
5, 12
GND
Circuit ground connection.
6
VCC
Input voltage pin. This pin provides the power for the internal control circuitry and gate driver. Connect a 22uF
(minimum) bypass capacitor to ground.
(minimum) bypass capacitor to ground.
7
ASNS
PWM output of the TRIAC dim decoder circuit. Outputs a 0 to 4V PWM signal with a duty cycle proportional to the
TRIAC dimmer on-time.
TRIAC dimmer on-time.
8
FLTR1
First filter input. The 120Hz PWM signal from ASNS is filtered to a DC signal and compared to a 1 to 3V, 5.85 kHz
ramp to generate a higher frequency PWM signal with a duty cycle proportional to the TRIAC dimmer firing angle.
Pull above 4.9V (typical) to TRI-STAT DIM.
ramp to generate a higher frequency PWM signal with a duty cycle proportional to the TRIAC dimmer firing angle.
Pull above 4.9V (typical) to TRI-STAT DIM.
9
DIM
Input/output dual function dim pin. This pin can be driven with an external PWM signal to dim the LEDs. It may
also be used as an output signal and connected to the DIM pin of other LM3448/LM3445 devices or LED drivers
to dim multiple LED circuits simultaneously.
also be used as an output signal and connected to the DIM pin of other LM3448/LM3445 devices or LED drivers
to dim multiple LED circuits simultaneously.
10
COFF
OFF time setting pin. A user set current and capacitor connected from the output to this pin sets the constant OFF
time of the switching controller.
time of the switching controller.
11
FLTR2
Second filter input. A capacitor tied to this pin filters the PWM dimming signal to supply a DC voltage to control the
LED current. Could also be used as an analog dimming input.
LED current. Could also be used as an analog dimming input.
13
ISNS
LED current sense pin (internally connected to MOSFET source). Connect a resistor from ISNS to GND to set the
maximum LED current.
maximum LED current.
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
during storage or handling to prevent electrostatic damage to the MOS gates.
2
Copyright © 2011–2013, Texas Instruments Incorporated
Product Folder Links: