Texas Instruments IC MCU 16B MSP430G2131IPW14 TSSOP-14 TID MSP430G2131IPW14 Datenbogen
Produktcode
MSP430G2131IPW14
Supply voltage range,
during flash memory
programming
during flash memory
programming
Supply voltage range,
during program execution
during program execution
Legend :
16 MHz
System Frequency - MHz
12 MHz
6 MHz
1.8 V
Supply Voltage - V
3.3 V
2.7 V
2.2 V
3.6 V
MSP430G2x31
MSP430G2x21
MSP430G2x21
SLAS694J – FEBRUARY 2010 – REVISED FEBRUARY 2013
Absolute Maximum Ratings
(1)
Voltage applied at V
CC
to V
SS
–0.3 V to 4.1 V
Voltage applied to any pin
(2)
–0.3 V to V
CC
+ 0.3 V
Diode current at any device pin
±2 mA
Unprogrammed device
–55°C to 150°C
Storage temperature range, T
stg
(3)
Programmed device
–55°C to 150°C
(1)
Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2)
All voltages referenced to V
SS
. The JTAG fuse-blow voltage, V
FB
, is allowed to exceed the absolute maximum rating. The voltage is
applied to the TEST pin when blowing the JTAG fuse.
(3)
Higher temperature may be applied during board soldering according to the current JEDEC J-STD-020 specification with peak reflow
temperatures not higher than classified on the device label on the shipping boxes or reels.
temperatures not higher than classified on the device label on the shipping boxes or reels.
Recommended Operating Conditions
Typical values are specified at V
CC
= 3.3 V and T
A
= 25°C (unless otherwise noted)
MIN
NOM
MAX
UNIT
During program execution
1.8
3.6
V
CC
Supply voltage
V
During flash programming
2.2
3.6
V
SS
Supply voltage
0
V
T
A
Operating free-air temperature
I version
–40
85
°C
V
CC
= 1.8 V,
dc
6
Duty cycle = 50% ± 10%
V
CC
= 2.7 V,
f
SYSTEM
Processor frequency (maximum MCLK frequency)
(1) (2)
dc
12
MHz
Duty cycle = 50% ± 10%
V
CC
= 3.3 V,
dc
16
Duty cycle = 50% ± 10%
(1)
The MSP430 CPU is clocked directly with MCLK. Both the high and low phase of MCLK must not exceed the pulse width of the
specified maximum frequency.
specified maximum frequency.
(2)
Modules might have a different maximum input clock specification. See the specification of the respective module in this data sheet.
Note:
Minimum processor frequency is defined by system clock. Flash program or erase operations require a minimum V
CC
of 2.2 V.
Figure 1. Safe Operating Area
16
Copyright © 2010–2013, Texas Instruments Incorporated