Texas Instruments TPS61050-215 Evaluation Kit TPS61050EVM-215 TPS61050EVM-215 TPS61050EVM-215 Benutzerhandbuch
Produktcode
TPS61050EVM-215
www.ti.com
2.3
Hardware Setup
Host
Computer
USB Cable
USB
Interface
Adapter
Green LED
Indicates
Power
10-Pin
Ribbon
Cable
EVM Board
USB Interface Adaptor Quick Connection Diagram
Setup
Table 1 below shows the board's DEFAULT jumper settings.
Table 1. Jumper Settings
JUMPER
DEFAULT
JP1
Installed
JP2
Uninstalled
JP3
Uninstalled
JP4
Uninstalled
JP5
Installed
Connect the USB-TO-GPIO adapter to your PC using the supplied USB cable. Connect the
TPS61050/2EVM's connector J3 to the USB-TO_GPIO adapter using the supplied 10-pin ribbon cable.
The connectors on the ribbon cable are keyed to prevent incorrect installation.
TPS61050/2EVM's connector J3 to the USB-TO_GPIO adapter using the supplied 10-pin ribbon cable.
The connectors on the ribbon cable are keyed to prevent incorrect installation.
Connect at least a 2-A rated input power supply set to provide between 2.5 V and 6.0 V output to J1 and
J2. The leads should be very short. Additional input capacitance may be required in order to mitigate the
inductive voltage droop that occurs at torch current start up and especially when the flash pulse occurs
(see figures 5 and 6). Turn on the power supply.
J2. The leads should be very short. Additional input capacitance may be required in order to mitigate the
inductive voltage droop that occurs at torch current start up and especially when the flash pulse occurs
(see figures 5 and 6). Turn on the power supply.
WARNING
This EVM has a white LED that flashes very brightly. Protective eye
wear and/or a diffuser to cover the white LED during operation is
recommended.
wear and/or a diffuser to cover the white LED during operation is
recommended.
SLVU202B – May 2007 – Revised November 2007
TPS61050EVM-215 and TPS61052EVM-215
5