Texas Instruments TPS75105DSK-529 Evaluation Board TPS75105DSKEVM-529 TPS75105DSKEVM-529 TPS75105DSKEVM-529 Benutzerhandbuch
Produktcode
TPS75105DSKEVM-529
Preface
SLVU334 – August 2009
About This Manual
This User’s Guide describes the characteristics, operation, and use of the TPS75105DSKEVM-529
Evaluation Module (EVM). This EVM demonstrates the Texas Instruments TPS75105 low-dropout,
two-bank LED driver with PWM brightness control. This User’s Guide includes setup instructions, a
schematic diagram, a bill of materials (BOM), and PCB layout drawings for the evaluation module.
Evaluation Module (EVM). This EVM demonstrates the Texas Instruments TPS75105 low-dropout,
two-bank LED driver with PWM brightness control. This User’s Guide includes setup instructions, a
schematic diagram, a bill of materials (BOM), and PCB layout drawings for the evaluation module.
How to Use This Manual
This document contains the following chapters:
•
•
Chapter 1 – Introduction
•
Chapter 2 – Setup
•
Chapter 3 – Board Layout
•
Chapter 4 – Schematic and Bill of Materials
Related Documentation From Texas Instruments
TPS7510x Low Dropout, Two-Bank LED Driver With PWM Brightness Controldata sheet (
If You Need Assistance
Please contact your local TI sales representative.
FCC Warning
This equipment is intended for use in a laboratory test environment only. It generates, uses, and can
radiate radio frequency energy and has not been tested for compliance with the limits of computing
devices pursuant to subpart J of part 15 of FCC rules, which are designed to provide reasonable
protection against radio frequency interference. Operation of this equipment in other environments may
cause interference with radio communications, in which case the user at his own expense will be required
to take whatever measures may be required to correct this interference.
radiate radio frequency energy and has not been tested for compliance with the limits of computing
devices pursuant to subpart J of part 15 of FCC rules, which are designed to provide reasonable
protection against radio frequency interference. Operation of this equipment in other environments may
cause interference with radio communications, in which case the user at his own expense will be required
to take whatever measures may be required to correct this interference.
3
SLVU334 – August 2009
Copyright © 2009, Texas Instruments Incorporated