Texas Instruments CDCE72010EVM - CDCE72010EVM Evaluation Module CDCE72010EVM CDCE72010EVM Datenbogen
Produktcode
CDCE72010EVM
Note program file location as the
USB controller driver is in the
same location!
USB controller driver is in the
same location!
Installing the GUI Interface and USB Driver
www.ti.com
Connect the USB cable to the EVM. If The Windows™ operating system asks for an appropriate driver, do
not use the automatic search option. Select a manual installation, and when prompted for the driver
location, browse to the CDCE72010 GUI file folder that was used during instillation. If the Windows
operating system does not ask for a driver, no action is required.
not use the automatic search option. Select a manual installation, and when prompted for the driver
location, browse to the CDCE72010 GUI file folder that was used during instillation. If the Windows
operating system does not ask for a driver, no action is required.
After the USB driver installation, the GUI software must connect properly and be ready for use. A green
light in the USB Status and SPI Bus Status boxes indicates good USB connection, and a red light
indicates faulty USB connection or faulty SPI bus.
light in the USB Status and SPI Bus Status boxes indicates good USB connection, and a red light
indicates faulty USB connection or faulty SPI bus.
1.5-GHz Low-Phase Noise Clock Evaluation Board
4
SLAU250 – May 2008