Texas Instruments Evaluation Board for the LM20333 LM20333EVAL/NOPB LM20333EVAL/NOPB Datenbogen
Produktcode
LM20333EVAL/NOPB
R2 =
- 1
V
TO
1.25
x R3
PCB Layout
6.11 Programmable UVLO: R2 and R3
The resistors labeled R2 and R3 create a voltage divider from V
IN
to the enable pin that can be used to set
the turn-on threshold or UVLO of the voltage regulator. To allow evaluation of the device down to 4.5V
these components are not installed. To change the turn-on threshold of the device a 10 k
these components are not installed. To change the turn-on threshold of the device a 10 k
Ω
resistor is
recommended for R3 and the value of R2 can be calculated using the equation:
(9)
7
PCB Layout
Figure 6. Top Layer
Figure 7. Mid Layer1
9
SNVA325B – May 2008 – Revised May 2013
AN-1791 LM20333 Evaluation Board
Copyright © 2008–2013, Texas Instruments Incorporated