Texas Instruments TPD12S016PWR Evaluation Module TPD12S016PWREVM TPD12S016PWREVM Datenbogen
Produktcode
TPD12S016PWREVM
EVM Configuration
4
EVM Configuration
The TPD12S016 EVM has three separate sections,
the TOP, MIDDLE, and BOTTOM sections. Each
section includes a TPD12S016, input/output (IO) ports,
and jumper switches for enabling or disabling the
TPD12S016
the TOP, MIDDLE, and BOTTOM sections. Each
section includes a TPD12S016, input/output (IO) ports,
and jumper switches for enabling or disabling the
TPD12S016
’
s Level Shifter (LS), Hot Plug Detect and
5VOUT. VCC can be powered by either an HDMI input
or a 5V SUPPLY banana clip.
or a 5V SUPPLY banana clip.
OUTPUT is side B; INPUT is side A. TOP, MIDDLE,
and BOTTOM sections are all supplied with power
using VBAT, VCCA, and GND.
and BOTTOM sections are all supplied with power
using VBAT, VCCA, and GND.
1. The TOP section has Type-A HDMI male
connectors for IO.
2. The MIDDLE section has Type-C HDMI male
connectors for IO.
3. The BOTTOM section has a Type-A male
connector as input for the four differential pair
signals only. For probe testing of the high-speed
differential signals, test points are provided on the
board. Configurable output loads using R1-R8
signals only. For probe testing of the high-speed
differential signals, test points are provided on the
board. Configurable output loads using R1-R8
&
C1-C4 are provided. This configuration provides a
means for developing eye diagrams under no load
or loaded conditions
means for developing eye diagrams under no load
or loaded conditions
Jumper Switch Configurations
LS (LS_OE)
disabled
enabled
CT_CP_HPD
disabled
enabled
5V
Using the +5Vout of TPD12S016
Bypass +5VOUT of TPD12S016
Selects source of output
'
s +5
Power Signal (Pin 18)
2
TPD12S016 Evaluation Module
SLLU154
–
September 2011
Copyright
©
2011, Texas Instruments Incorporated