Texas Instruments TPS2458 Hot Swap/ORing Controller Evaluation Module TPS2458EVM TPS2458EVM Datenbogen
Produktcode
TPS2458EVM
5.2
Jumper Installation
5.3
Test Results
5V/div
5A/div
5V/div
500μs/div
12VIN current
SLOT_PWR
(TP4)
/EN12
(TP8)
5V/div
2V/div
200mA/div
500μs/div
3V3IN Current
SLOT_MP
(TP5)
/EN3
(TP7)
Test Set-Up
www.ti.com
The TPS2458EVM makes use of various jumpers for quick change of functional configurations. Verify the
module was supplied with shunt jumpers installed across the headers listed in
module was supplied with shunt jumpers installed across the headers listed in
. For 3-pin headers,
note the pin pairs to be connected. Reconfigure jumper connections if necessary.
Table 4. Initial Jumper Settings
SIGNAL AND CONTROL JUMPERS
J7, J9
J11–J16
On the EVM board, place the ENABLE slide switches, located along the bottom edge of the PCB, in the
initial positions shown in
initial positions shown in
Table 5. ENABLE Switch Initial Positions
SECTION
SWITCH NAME
INITIAL POSITION
SLOT
MP
DIS
PWR
DIS
PWR_OR
ENA
Set all 4 DIP positions of switch S4 to the CLOSED position.
Figure 3. Output Ramp-Up Waveforms –
Figure 4. Output Ramp-Up Waveforms –
SLOT_PWR Rail
SLOT_MP Rail
TPS2458 ATCA™ AdvancedMC™ Controller
6
SLUU348A – February 2009 – Revised August 2009