Texas Instruments TMP708 Evaluation Module TMP708EVM TMP708EVM Datenbogen
Produktcode
TMP708EVM
TMP708/709EVM Hardware Overview and Setup
1.2
Related Documentation from Texas Instruments
The following documents provide information regarding Texas Instruments' integrated circuits used in the
assembly of the TMP708/709EVM. This user's guide is available from the TI web site under literature
number SBOU120. Any letter appended to the literature number corresponds to the document revision
that is current at the time of the writing of this document. Newer revisions may be available from the
assembly of the TMP708/709EVM. This user's guide is available from the TI web site under literature
number SBOU120. Any letter appended to the literature number corresponds to the document revision
that is current at the time of the writing of this document. Newer revisions may be available from the
, or call the Texas Instruments' Literature Response Center at (800) 477-8924 or the Product
Information Center at (972) 644-5580. When ordering, identify the document by both title and literature
number.
number.
Table 2. Related Documentation
Document
Literature Number
TMP708 product data sheet
SBOSxxx
TMP709 product data sheet
2
TMP708/709EVM Hardware Overview and Setup
This section describes the hardware and setup for the TMP708/709EVM.
2.1
TMP708/709EVM Hardware Theory of Operation
The TMP708/709 test boards feature a power connector labeled J1. This off-board power is connected
directly to the TMP708/709 (depending on which EVM you are using). A low-dropout (LDO) regulator
provides power to two comparators which sense the output from the TMP708/709.
directly to the TMP708/709 (depending on which EVM you are using). A low-dropout (LDO) regulator
provides power to two comparators which sense the output from the TMP708/709.
Depending on the output, either a green LED or a red LED illuminates to visually represent the status of
the temperature switch. The temperature limit is determined by the resistor Rset; see Section 2.4.3.
the temperature switch. The temperature limit is determined by the resistor Rset; see Section 2.4.3.
The hysteresis setting is controlled by populating either R5 or R6 with a 0-
Ω
resistor. This behavior is
described in Section 2.4.2.
shows the basic interactions that occur on the TMP708/709 test board.
Figure 2. TMP708/709EVM Hardware Setup
3
SBOU120
–
December 2011
TMP708/709EVM Evaluation Board and Software Tutorial
Copyright
©
2011, Texas Instruments Incorporated